A lot of small jobs to do after getting the rig up. Here are a few...
![]()
![]()
![]()
![]()
Mast wiring and fitting the cabin sole boards around the mast.
![]()
![]()
![]()
![]()
![]()
![]()
Adding silicon bronze armour to the bowsprit to protect from the chain.
Mast wiring and fitting the cabin sole boards around the mast.
The Plath windlass needs a chain stripper. Fabricated out of 1/4" bronze plate.
Chain stripper installed. Has a lanyard hole for the chain hawse cover.
For some reason the Plath windlass handle was not only very short but also painted steel, not even galvanized. Here is a new stainless steel one.
A piece of the vast amount of rigging detail work.
The inner neoprene mast boot.
Outer mast boot